QUICK START GUIDE
Disconnect cables
Take out camera
Take out battery and flash trigger
Take off lens and ball head plate
Install settings camera
Put the lens back
Place camera on ball head
Take test photo
STEPS EXPLAINED
Step 1. Disconnect cables
Open the Capture Tower at the back to be able to reach the camera. Disconnect the USB mini cable from the camera and disconnect the trigger cable.
Step 2. Take out camera
Pull the black handle down and the grey handle towards you to disconnect the the camera from the ball head.
Step 3. Take out battery and flash trigger
Open the battery cover and remove the battery from the camera.
Step 4. Take off lens and ball head plate
Use the button next to the lens to disconnect the lens from the camera. Now unscrew the ball head plate from the bottom of the camera.
Step 5. Prepare new camera
Connect the lens to the camera and put the ball head plate on the new camera. Now put the battery into the cable.
Step 5. Install settings camera
Turn on the camera with the on / off switch on top. Now set all settings. You can use the old camera to take over the settings.
Step 6. Put the lens back
Get the lens and put it on the camera. Make sure the lens and the mirror in the camera are free of dust.
Step 7. Place camera on ball head
Now place the camera back on it's ball head and reconnect all cables and the flash trigger.
Step 8. Take test photo
Take a test photo and check it in your GoPhoto - CMS to make sure everything is set up as it should.
Troubleshooting:
Having trouble connecting your replacing your camera? Please contact the GoPhoto Support Team via chat.